Advertisement


 

 

 

 

Vespa forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.





Pages: [1]
Author Topic: Question Delorto 20.17B
Oelhunden
Newbie
Posts: 1
Permalink
Oelhunden
Post Question Delorto 20.17B
on: June 3, 2022, 08:29
Quote

Hi,

after hypersonic clean of my carb there was a small brass ring in the “bathtub”

The only place it could fit is in the bottom of the hole where the main jet is.

Then it should have been vibrated loose.

It is not on any exploded views, so if it is from there it should have been pressurefitted from the factory.

It is 5mm in outer diamater and 3,1mm in inner diameter.

It looks like the main jet could sit fine in it.

But I can’t see if the bottom of the hole is straight or if it ends in a hole with angled sides. Old eyes winking smiley

Does anyone have a 20.17b housing who can say if there is a brass ring/washer in the bottom of the main jet hole?

It could also be that it comes from another cleaning before me.

Thank you

Thomas
Image
Image

Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.01 seconds.


Since August 2011 - © Aerostato, Seattle - All Rights Reserved.